This is the standard 8" rim (hub) used on both Peter Lynn and Flexifoil buggies (depending on bearing size).  They will fit the standard 4.5" x 16" tires, the "Extra Wide" 6.5 x 16" tires or Peter Lynn "Bigfoot" tires 10" x 21".

These come shipped with a hole for an inner tube valve stem, but if you want to go tubeless, just insert a standard tubeless valve stem available at the car parts store (smear a bit of dish-washing soap around it and pull it through with a big pair of pliers).

There are two rim choices:  One that fits EITHER 12 mm or 15 mm bearings or one that fits ONLY 20 mm.  You can order either with or without bearings and spacer.  The spacer  is a steel tube that fits inside the rim between the bearings and the axle bolt goes through it.  The spacer takes the compression load of the axle bolt and mounting the wheel without it will destroy the rim.

In the near future, only the hub for 20 mm bearings will be available and a bushing insert will be provided to accommodate the smaller bearing sizes.

NOTE: Some bearings may be sourced locally from commercial industrial suppliers and are of same or higher grade as original suppliers.

Application Chart...

Bearing Size	Buggy Application
12 x 32 mm	Front Wheel All Peter Lynn  Buggies, Rear Wheel PL ST & Folding, Flexifoil Front and Rear
15 x 32 mm	Rear Wheel Peter Lynn XR & Bigfoot
20 x 47 mm	Rear Wheel Peter Lynn XR+, BigFoot+, Folding+; All Wheels on Ivanpah Buggy